Use Method Of Hydraulic Bending Machine

1, the first is to connect the power supply, open the key switch on the control panel, and then press the oil pump to start, so you can hear the rotating sound of the oil pump. At this time the machine does not move

2, stroke adjustment, the use of bending machine must pay attention to adjust the itinerary, must be tested before bending. When the upper die of the bending machine goes down to the bottom, there must be a gap in the thickness of the plate. Otherwise it will damage the mold and the machine. The stroke adjustment also has electric quick adjustment and manual trimming.

3, the choice of bending notch, generally choose the width of the plate thickness of 8 times the width of the notch. For bending 4mm sheet, 32 notches should be chosen.

4, the rear block adjustment generally have electric quick adjustment and manual fine-tuning, the method is the same as the plate shears.

5, step on the foot switch to start bending, bending machine and cutting machine is different, can be released at any time, loosen the foot, bending machine will stop, step on the down.

hydraulic bending machine.jpg


ZHEJIANG WILLING INTERNATIOANAL CO., LTD 

Address: No.307,#1 West Gaoxin Rd, ETDZ´╝îTongxiang, Zhejiang, China

Tel:        +86-573-88197066 

Fax:       +86-573-88196600 

Phone:  +86-17757308015 

               +86-13456824686

E-mail:  office@willingtec.com

              monica@willingint.com