Cold-bending Machinery And Equipment In The Use Of Precautions

With the continuous development of China's industry, cold forming technology has also been rapid development. Cold-formed machinery has become indispensable machinery for some specialized factories. Then cold-bending machinery and equipment also have the need to pay attention to the place.

First of all, to choose a flat surface, put the machine steady, you can pull the chassis feet so that the machine panel easy to observe. Insert the plug on the hand-held sensor into the socket on the panel and tighten it, pay attention to positioning the notch.

Second, insert the plug of the power cord into the socket on the rear panel of the chassis and plug the power supply socket into the other end. Be sure to use single-phase three-wire power supply. Then, open the "POWER SW." On the rear panel of the chassis and press the "SWITCHING" button on the panel. When the "WARM UP" green indicator is on, the machine will work. Hold down the "SETTING BUTTON" button, set to a suitable value, usually between 0.5-2.0 seconds.

Again, place the sensor tip on the container lid and press the start button on the handle. The "HEATING" red indicator light is on, the sensor tip is not moving, and the "HEATING" red indicator light is off Then remove the sensor head.

Finally, wait for "WARM UP" green light or buzzer beep "beep" prompt and then proceed to the next container sealing operation. Check the sealing quality, according to the different materials, the diameter of the container and the production efficiency, proper trimming "SETTING button (SETTING BUTTON) key, making the best sealing quality.